P0606 ECM / PCM Processor - Automotive Diagnosis

COMPONENT LOCATION

GENERAL DESCRIPTION

A malfunction is detected by using a checksum technique for verifying data. The digital data is composed of zeros and ones. A checksum is the total of all ones in a string of data. By comparing the checksum value with a stored value, a malfunction can be detected.

DTC DESCRIPTION

Checking ECM under detecting condition, if internal error is detected, ECM sets P0606.

DTC DETECTING CONDITION

Item

Detecting Condition

Possible cause

DTC Strategy

Check ECM internal error

1.	Faulty ECM

Enable Conditions

7V < Battery voltage < 20V

Threshold value

ECM internal error (A/D unit error)

Diagnosis Time

Continuous

MIL On Condition

1 driving cycle

MONITOR GDS DATA

1.	Connect GDS to Data Link Connector(DLC).

2.

IG “ON”.

3.	Select “DTC” button, and then Press “DTC Status” to check DTC’s information from the DTCs menu.

4.	Read “DTC Status” parameter.

5.

Is parameter displayed “Present fault”?

	▶ Go to “Terminal and Connector inspection” procedure.
	▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary

TERMINAL AND CONNECTOR INSPECTION

1.	Many malfunctions in the electrical system are caused by poor harness and terminal connections. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

2.	Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

3.

Has a problem been found?

▶ Repair as necessary and go to “Verification of Vehicle Repair” procedure.

▶ Substitute with a known – good ECM and check for proper operation. If the problem is corrected, replace ECM and go to “Verification of Vehicle Repair” procedure.

There is a memory reset function on GDS that can erase optional parts automatically detected and memorized by ECM. Before or after testing ECM on the vehicle, use this function to reuse the ECM on the others.

New Videos on our YouTube Channel Every Week, Subscribe Now!

Tags:

Comments are closed